Concrete Mould are Easily Cast by Using atemping bar or a vibrating table.
The machine consists of a vibrating frame assembly and an electric motor mounted on a sturdy base. The complete frame assembly consists of a vice to hold a 7.06cm cube mould and two studs threaded at top and a hopper to feed the sample in the mould. This assembly is supported on four springs and has an in built rotating shaft which rotates eccentrically and thus imparts vibrations to the entire frame. A balance weight is an integral bottom part of the frame. The centre of gravity of the assembly is brought to the centre of the eccentric shaft or within a distance of 25mm below it. The electric motor drives the shaft of the frame and thus imparts required vibrations to the mould. The frequency of vibrations is 12000 +-400 vibration per minute. Supplied complete with on 7.06cm cube mould with loose base plate, a time switch 0-5 mins x1 min and certificate of vibration from a standard laboratory, spares: set of springs, belt and belth guard.